Mitsubishi RS232/485/LAN Serial Communication Control Handbuch Seite 278

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 349
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 277
Chapter2 Connection to a PLC
2-278
14.4 Environment Settings
14.4.1 MP920, MP930, MP2300
Items Details
Serial Interface RS-232C
Protocol MEMOBUS RTU
Slave Address 1 – 63 (DEC)
Baud Rate (bps) 9600/19200
Data Bits (bit) 8 (fixed)
Parity None, Even, Odd
Stop Bits (bit) 1, 2
Flow Control ER control
- It is necessary to set up transmission form by the rudder program.
- Please set up the head register by the side of PLC as follows. Moreover, please give offset
of each register as 0.
[Module detailed setup]
"Setup of a slave I/F register" "Head REG"
"reading of an Inputs Status " IW0000
"reading of an Inputs Registers " IW0000
"reading/writing" of a Coil MW00000
"reading/writing" of a Holding Registers MW00000
Seitenansicht 277
1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 348 349

Kommentare zu diesen Handbüchern

Keine Kommentare