Mitsubishi MR-508XL Spezifikationen PDF herunterladen (Seite 45)

7.45

For Technical Assistance: 800-442-4622

Bimba Digital Panel Meter

Position Feedback

Cylinders

Position Feedback

Cylinder Non-Contact

Position Feedback

Cylinder Rod Lock

Position Feedback

Cylinder Accessories

Position Feedback

Pneu-Turn

Position

Control System

Digital Panel Meter Electronic Controller

PFC/PCS/PTF

Application Checklist

DPM Specifications Continued

Optional Quad Relay Card:

(Optional Accessory Card DPM-R):

Type: Four FORM-A relays

Isolation To Sensor & User Input

Commons: 2300 Vrms for 1 min.

Contact Rating: One Relay Energized:

3 amps @ 250 VAC or 30 VDC (resistive

load), 1/10 HP @ 120 VAC, inductive

load. Total current with all four relays

energized not to exceed 4 amps

Life Expectancy: 100K cycles min. at

full load rating. External RC snubber

extends relay life for operation with

inductive loads.

17. ENVIRONMENTAL CONDITIONS:

Operating Temperature Range: 0 to 50°C (0 to 45°C with all

three plug-in cards installed)

Storage Temperature Range: -40 to 60°C

Operating and Storage Humidity 0 to 85% max. non-

condensing

Attitude: Up to 2000 meters

18. CERTIFICATIONS AND COMPLIANCES:

ELECTROMAGNETIC COMPATIBILITY

Notes:

1. Self-recoverable loss of performance during EMI disturbance

at 10 V/m: Measurement error less than 2% of full scale.

For operation without loss of performance:

Mount unit in a metal enclosure (Buckeye SM7013-0 or equiva-

lent)

Route power and I/O cables in metal conduit connected to earth

ground.

Refer to the Application Guide for additional EMC information.

Immunity to EN 50082-2

electrostatic discharge EN 61000-4-2 level 3; 8 Kv air

electromagnetic RF fields EN 61000-4-3 level 3; 10 V/m

80 MHz - 1 GHz

fast transients (burst) EN 61000-4-4 level 4; 2 Kv I/O

level 3; 2 Kv power

RF conducted interference EN 61000-4-6 level 3; 10 V/rms

150 KHz - 80 MHz

simulation of cordless telephones ENV 50204 level 3; 10 V/m

900 MHz

5 MHz

200 Hz, 50% duty cycle

Emissions to EN 50081-2

RF interference EN 55011 enclosure class A

power mains class A

19. CONNECTIONS: High compression cage-clamp terminal

block

Wire Strip Length: 0.35" (9 mm)

Wire Gauge Capacity: One 14 AWG solid or Two 18 AWG

20. CONSTRUCTION: This unit is rated for NEMA 4X/IP65

indoor use. IP20 Touch safe. Installation Category II, Pollution

Degree 2. One piece bezel/case. Flame resistant. Synthetic

rubber keypad. Panel gasket and mounting clip included.

21. Weight: 10.4 oz. (295 g)

Safety Summary

All safety related regulations, local codes and

instructions that appear in the manual or on

equipment must be observed to ensure personal

safety and to prevent damage to either the

instrument or equipment connected to it. If

equipment is used in a manner not specified by

the manufacturer, the protection provided by the

equipment may be impaired.

Do not use this unit to directly command motors,

valves, or other actuators not equipped with

safeguards. To do so can be potentially harmful

to persons or equipment in the event of a fault to

the unit.

KEY DISPLAY MODE OPERATION:

DSP Index display through max/min/total/input readouts

PAR Access parameter list

F1p Function key #1; hold for 3 seconds for Second Function #1

F2q Function key #2; hold for 3 seconds for Second Function #2

RST Reset (function key)

PROGRAMMING MODE OPERATION

Quit programming and return to display mode

Store selected parameter and index to next parameter

Increment selected parameter value

Decrement selected parameter value

Hold with F1p, F2q to scroll value by x1000

QUAD RELAY

OUTPUT FIELD

TERMINALS

RLY1

COMM

RLY2

RLY3

COMM

RLY4

Jumper Link Functions

USER INPUT LOGIC SELECT

SOURCE

SINK

FRONT

User Input Source or Sink Select

Front Panel

Display

Readout

Legends

SP1

SP2

SP3

SP4

DSP

PAR

F2▼

F1▲

RST

MAX

MIN

TOT

Custom

Units

Overlay

Setpoint

Alarm

Annunciators

8.8.8.8.8.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

Mitsubishi MR-508XL Spezifikationen Seite 45

Kommentare zu diesen Handbüchern