Mitsubishi Q62DAN Bedienungsanleitung PDF herunterladen (Seite 28)

1 - 13 1 - 13

MELSEC-Q

1 GENERAL SPECIFICATIONS AND PRECAUTIONS FOR USE OF I/O

MODULE

1.2.5 Interrupt module

(1) If setting the response time during the interrupt input operation of QI60 or QX40H,

QX70H, QX80H, and QX90H, use the module whose contents are shown below.

The response time cannot be set with other contents (fixed at 0.2ms.).

Product name Contents

PLC CPU Product information "021120000000000-B" or later

GX Developer SW6D5C-GPPW or later

For how to check product information of the CPU module, refer to QCPU User's

Manual (Hardware Design, Maintenance and Inspection).

1.2.6 Installation and wiring

(1) Insulation-sleeved-solderless terminals cannot be used with the terminal block.

It is recommended to cover the wire connections of the solderless terminals with

mark or insulation tubes.

(2) Use wires of 0.3 to 0.75mm

core and 2.8mm (0.11in.) OD max. to connect to the

terminal block. When using a wire whose core is 0.75mm or more, it is preferable to

use the spring clamp terminal block(Q6TE-18S).

(3) Tighten the module fixing and terminal block screws to the torques in the following

ranges.

Screw location Tightening torque range

Module fixing screw (M3 12 screw) 36 to 48 N•cm

I/O module terminal block screw (M3 screw) 42 to 58 N•cm

I/O module terminal block mounting screw (M3 screw) 66 to 89 N•cm

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 143 144

Keine Kommentare

Mitsubishi Q62DAN Bedienungsanleitung Seite 28