Mitsubishi MOTION CONTROLLERS Q173DCPU Bedienerhandbuch PDF herunterladen (Seite 150)

4 - 5

4 INSTALLATION AND WIRING

(2) Module mounting position

Keep the clearances shown below between the top/bottom faces of the module

and other structures or parts to ensure good ventilation and facilitate module

replacement.

(Note): It is impossible to mount the main base unit by DIN rail.

5mm(0.20inch)

or more

(Note-1)

MITSUBISHI

Top of panel or wiring duct

Base unit

Motion CPU module Motion CPU module

100mm

(3.94inch)

or more

Door

(Note-2)

Panel

5mm(0.20inch)

or more

(Note-1): 20mm (0.79inch) or more when the adjacent module is not removed and the extension cable is connected.

(Note-2): Q173DSCPU/Q172DSCPU use 70mm (2.76inch) or more

Q173DCPU(-S1)/Q172DCPU(-S1) use 100mm (3.94inch) or more

40mm

(1.57inch)

or more

(3) Module mounting orientation

(a) Mount the Motion controller in the orientation shown below to ensure good

ventilation for heat release.

(b) Do not use it in either of the orientations shown below.

Vertical

Flat Upside down

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 251 252

Keine Kommentare

Mitsubishi MOTION CONTROLLERS Q173DCPU Bedienerhandbuch Seite 150